COLOR TYPE :: TFT  COLOR TYPE :: B/W
 CHARACTER TYPE :: WITH LED BACKLIGHT  CHARACTER TYPE :: NO BACKLIGHT
 GRAPHIC TYPE :: WITH LED BACKLIGHT  GRAPHIC TYPE :: NO BACKLIGHT
 Module 
COLOR TYPE -TRT
128 x RGB(H) x 160(V)       TFT (1.8 inch) Model : EDG180A01TOXGA
DIMENSIONAL DRAWING DOWNLOAD    form in PDF format
FEATURE : BLOCK DIAGRAM
  1. Display Mode: TFT(1.8 inch)/Negative/
                           Transmissive
  2. Driving voltage: VDD=2.8V
  3. Viewing angle: 12 O'Clock
  4. Operating temp: -20C~+70C
    Storage temp: -30C~+80C
  5. Drive IC: Sunplus SPFD5414
  6. Interface: 80 PARALLEL
  7. Unspecified tolerance is +0.2mm
  8. Backlight Color: White LED;Vf=3.2V;If=15mA
OPTICAL SPECIFICATION
ITEM SYMBOL CONDITIONS MIN TYPE MAX UNIT REMARK
Esponse time Rise Tr =0 - 12 - ms Note4
Fall Tf - 18 - ms
Contrast ratio CR At optimize viewing angle 250 300 - - Note5
Transmilttance --     6.5   %  
Viewing Angle Top --- CR5 40 60 - deg. Note6
Bottom 10 20 -
Left 30 45 -
Right 30 45 -
Color Tone White Wx =0 0.26 0.31 0.36 - Note7
Wy 0.28 0.33 0.38

Input/Output Signal Interface

NO PIN name I/O Description Remark NO PIN name I/O Description Remark
1 BL_K P

Anode of LED

  11 /RD I This pin is write control signal.  
2 BL_A P Gathodo of LED   12 DB7 I - Data  Bus  
- DB0 IS LSB
- DB7 IS MSB		  
3 VSS P System Ground   13 DB6 I  
4 VDD P System power supply   14 DB5 I  
5 NC N No connection   15 DB4 I  
6 NC N No connection   16 DB3 I  
7 /CS I This pin is used for chip select signals.(Active low)   17 DB2 I  
8 /RESET I When /RESET is L, an internal reset is performed   18 DB1 I  
9 RS I Command/Data selection   19 DB0 I  
10 /WR I This pin is write control signal.   20 GND P Ground