COLOR TYPE :: TFT  COLOR TYPE :: B/W
 CHARACTER TYPE :: WITH LED BACKLIGHT  CHARACTER TYPE :: NO BACKLIGHT
 GRAPHIC TYPE :: WITH LED BACKLIGHT  GRAPHIC TYPE :: NO BACKLIGHT
 Module 
COLOR TYPE -TRT
240 x RGB(H) x 320(V)       TFT (2.4 inch) Model : EDG024A01TOXGC
DIMENSIONAL DRAWING DOWNLOAD    form in PDF format
FEATURE : BLOCK DIAGRAM
  1. Display Mode: TFT(2.41 inch)/Transmissive/
    Negative,VDD=2.8V
  2. Viewing angle: 12 O'Clock
  3. Operating temp: -20C~+70C
    Storage temp: -30C~+80C
  4. Drive IC: SPFD5408B
  5. Unmarked tolerance: +0.2mm
  6. Backlight Color: White(4LEDs);Vb=12v; Ib= 18mA; Luminance: min2500cd/m2
  7. ROHS request
ELECTRO-OPTICAL CHARACTERISTICS
ITEM SYMBOL CONDITIONS MIN TYPE MAX UNIT REMARK
Esponse time Rise Tr =0 - 12 - ms Note4
Fall Tf - 18 - ms
Contrast ratio CR At optimize viewing angle 250 300 - - Note5
Transmilttance %     6.0   %  
Viewing Angle Top --- CR5 40 60 - deg. Note6
Bottom 10 20 -
Left 30 45 -
Right 30 45 -
Color Tone White Wx =0 0.26 0.31 0.36 -  
Wy 0.28 0.33 0.38

Input/Output Signal Interface

NO PIN name I/O Description NO PIN name I/O Description
1

NC

 N No connection 29 RD I A read strobe signal and enables an operation to read out data when the signal is low.
2~5

PS0~PS3/ IM0~IM3

I Select a mode to interface to an MPU. In serial interface operation,the IM0 pin is used to set the ID Bit of device code. 30

WR

 I A write strobe signal and enables an operation to write data when the signal is low.
6

RESET

 I RESET pin. This is an active low signal. 31

DC

 I A register select signal.Low: select an index or status register.High: select a control register
7

VSYNC

 I Vertical synchronous signal
8 HSYNC I Horizontal synchronous signal 32 CS I A chip select signal.Low: the chip is selected and accessible.High: the chip is not selected and not accessible
9

DOTCLK

 I Dot clock
10 ENABLE I Data ENEABLE signal for RGB interface operation.Low: Select (access enabled)High: Not select (access inhibited) 33 VSS G

Ground

11~28 DB17~ DB0 I An 18-bit parallel bi-directional data bus for MPU system interface mode.8-bit I/F: DB[17:10] is used.9-bit I/F: DB[17:9] is used.16-bit I/F: DB[17:10] and DB[8:1] is used.18-bit I/F: DB[17:0] is used.18-bit parallel bi-directional data bus for RGB interface operation.6-bit RGB I/F: DB[17:12] are used.16-bit RGB I/F: DB[17:13] and DB[11:1] are used.18-bit RGB I/F: DB[17:1] are used. 34 VCC PI Internal logic power: VCC = 2.5V ~3.3V.
35 K PI Cathode of LED
36 A PI Anode of LED